Cisco ASR 914 Manual page 48

Installing the Cisco ASR 914 Router
Connecting Cables to the Patch Panel
Connecting Cables to the Patch Panel
Figure 23: Interface Module with the Connector
Figure 24: Patch Panel with the Connector
If you are connecting two T1/E1 interfaces to each other, you must cable both interfaces' patch panels together
using a T1 straight-through shielded cables. If both T1/E1 interfaces are connected to their patch panels in a
different configuration, use a T1 straight-through cable (standard RJ48C patch cable) to connect the patch
panels.
Caution
The intra-building port(s) of the equipment or subassembly is suitable for connection to intra-building or
unexposed wiring or cabling only. The intra-building port(s) of the equipment or subassembly must not be
metallically connected to interfaces which connect to the OSP or its wiring. These interfaces are designed for
use as intra-building interfaces only (Type 2 or Type 4 ports as described in GR-1089-CORE) and require
isolation from the exposed OSP cabling. The addition of primary protectors is not sufficient protection in
order to connect these interfaces metallically to OSP wiring. Statement 7005
Installing the Cisco ASR 914 Router
48