Installing The Fan Tray (A914-F2B-Air-Fan) - Cisco ASR 914 Manual

Hide thumbs Also See for ASR 914:

Table of Contents

Installing the Fan Tray (A914-F2B-AIR-FAN)

Step 4

Use a Phillips head screwdriver to attach the 2-hole ground lug and wire assembly to the router with the 2

pan-head Phillips head screws. For a 23-inch EIA rack, attach the 2-hole ground lug to the front or the rear

of the router.

Step 5

Connect the other end of the ground wire to a suitable grounding point at your site.

Installing the Fan Tray (A914-F2B-AIR-FAN)

The fan tray is a modular unit that provides cooling to the Cisco ASR 914 Router. Follow these steps to install

the fan tray in the chassis:

Warning

When removing the fan tray, keep your hands and fingers away from the spinning fan blades. Let the fan

blades completely stop before you remove the fan tray. Statement 258

Procedure

Step 1

Insert the fan trays gently inside the flap door to allow smooth entry of the fan as shown below. For more

instructions, refer to the caution label on the flap door.

Installing the Cisco ASR 914 Router

Table of Contents