Cisco ASR 914 Manual page 39

Installing the Cisco ASR 914 Router
Connecting a USB Flash Device
To connect a USB flash device to the Cisco ASR 914 Router, insert the memory stick in the USB port labeled
MEM. The Flash memory module can be inserted in only one way, and can be inserted or removed regardless
of whether the router is powered up or not.
The following figure shows the USB port connector on the Cisco ASR 914 Router.
Figure 19: Cisco ASR 914 Router Flash Token Memory Stick
Removing a USB Flash Device
To remove a USB flash device, pull the memory stick from the USB port.
Connecting Timing Cables
Note When installing the cabling to the RSPs, we recommend that you leave a service loop of extra cabling sufficient
to allow for fan tray removal.
Connecting Cables to the BITS Interface
Procedure
Step 1 Confirm that the router is powered off.
Step 2
Connect one end of the cable to the BITS port using a straight-through, shielded RJ48C-to-RJ48C cable.
Step 3 Connect the other end to the BTS patch or demarcation panel at your site.
Step 4
Turn on power to the router.
For information about the BITS port pinouts and using wire wrap adapters to connect to BITS interface, see
the Troubleshooting
Note
section.
Use of two BITS sources or a Y-cable is optional. Each BITS input port is routed to both RSPs, so
that SETS device on each RSP has visibility to both BITS inputs.
Connecting a USB Flash Device
Installing the Cisco ASR 914 Router
39