Download Print this page

Storage And Disposal - Husqvarna AX 36 Operator's Manual

Advertisement

Problem
Cause
The product
The vibrator head becomes too
stops after a
hot because the vibration time
while.
out of the concrete is too long.
The load is too high for the
product because the vibrator
head is too large.
The product uses too much
power. Too low input voltage.
The product uses too much
power because the vibrator
head motor is defective.
The product uses too much
power because the bearings in
the vibrator head are worn.
The product
The load is too high for the
operates at a
power source.
too low speed.
The product operates on 2 pha-
ses, not 3. 1 of the wires is bro-
ken in the hose or switch box.
The product operates on 2 pha-
ses, not 3. 1 of the pins in the
socket or plug is burned be-
cause of sparks.
Use of a 60 Hz power source in
a 50 Hz network.
Storage
Clean the product before storage.
Keep the product in a dry and frost-free area.
Keep the product in a locked area to prevent access
for children or persons that are not approved.
Disposal of the product
Obey the local recycling requirements and applicable
regulations.
12
Inspection
N/A
Examine the space between
the product and the rebars.
Examine the input voltage of
the power source.
Examine the ground insulation
of the vibrator head.
Examine the information on the
rating plate on the product.
Make sure that the power
source is of the correct type.
Measure the input power when
you use the product out of the
concrete.
Examine the information on the
rating plate on the product.
Make sure that the power
source is of the correct type.
Examine the resistance of the
product.
Examine the product visually
for damages.
Examine the rating plate on the
power source.

Storage and disposal

Solution
Remove the vibrator head from
the concrete and let it become
cool. Do not operate the vibra-
tor head for a long time without
load.
Make sure that the diameter of
the product is adapted to the
space between the rebars. The
vibrator head must not touch
the rebars.
Use an applicable extension
cable. Change the power
source type.
Replace the stator tube if it is
necessary.
Make sure that there is suffi-
cient power to the power
source and to the product.
Disassemble the vibrator head
and replace the bearings.
Make sure that there is suffi-
cient power to the power
source and to the product.
Examine and replace the dam-
aged wire.
Replace the power socket or
the power plug.
Use an applicable power
source.
When the product no longer is used, send it to the
dealer or discard it at a recycling location.
1006 - 002 - 27.03.2020

Advertisement

loading