Download Print this page
SoundTube IPD4-BGM Series Install Instructions

SoundTube IPD4-BGM Series Install Instructions

Advertisement

Quick Links

IPD4-BGM Series
IPD4-BGM Series
Tile bridge
Flexible conduit clamp
Cover plate
6-pin Euroblock connector
Box contents
1 Speaker
1 Flexible conduit clamp
1 6-pin Euroblock connector
1 Cover plate
1 Grille
1 Installation aid/paint mask
Warning
SoundTube speakers must be installed by a professional audio installer/contractor. For safety and for optimum audio
performance, installer must follow all directions issued by SoundTube Entertainment.
Haut-parleurs SoundTube doivent être installés par un installateur / contracor de l'audio professionnel. Par mesure de
sécurité et pour des performances audio optimales, l'installateur doit suivre toutes les directives émises par SoundTube
Entertainment.
Install Instructions For:
IPD4-CM52-BGM & IPD4-CM62-BGM
Ceiling thickness tolerances
Max
57.1 mm (2.25 in)
Speed Wing™ mounting arms
Baf e
|
1.435.647.9555
800.647.TUBE
© 2015 SoundTube Entertainment, Inc. All rights reserved. PN INS-IP4-BGM Rev11.10.2015
Warning
Do not spec or install speaker near support beam, ventilation duct or other
structure that may interfere with speaker function or dispersion.
Ne spéci ez pas ou installer haut-parleur près de poutre de support, une
conduite d'aération ou une autre structure qui pourrait interférer avec la fonction
haut-parleur ou de dispersion.
Min
0.9 mm (0.035 in)
|
www.soundtube.com

Advertisement

loading
Need help?

Need help?

Do you have a question about the IPD4-BGM Series and is the answer not in the manual?

Questions and answers

Summary of Contents for SoundTube IPD4-BGM Series

  • Page 1 Warning Warning SoundTube speakers must be installed by a professional audio installer/contractor. For safety and for optimum audio Do not spec or install speaker near support beam, ventilation duct or other performance, installer must follow all directions issued by SoundTube Entertainment.
  • Page 2 —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. 1.435.647.9555 | 800.647.TUBE | www.soundtube.com...
  • Page 3 2. Use included tile bridge 3. Use Rotozip or other tool to mark cutout in sheetrock. to cut hole. Hole Diameters CM42-EZs-II 165.1 mm (6.50 in) All other CMEZ, FS and BGM models 266.7 mm (10.50 in) 1.435.647.9555 | 800.647.TUBE | www.soundtube.com...
  • Page 4 10. Once all painting and placing the large end of the nish work is completed, clip over snap- t post (1), remove the paint mask. then sliding clip until small end snaps into place around post (2). 1.435.647.9555 | 800.647.TUBE | www.soundtube.com...

This manual is also suitable for:

Ipd4-cm52-bgmIpd4-cm62-bgm