Download
Share
Print this page
Schwinn Cadence Pro Install Manual
  1. Manuals
  2. Brands
  3. Schwinn Manuals
  4. Bicycle Accessories
  5. Cadence Pro
  6. Install manual
Schwinn Cadence Pro Install Manual

Schwinn Cadence Pro Install Manual

Core health & fitness for sc
Hide thumbs Also See for Cadence Pro:
1
2
3
4
5
6
7
8

Advertisement

Quick Links

Download this manual
Core Health & Fitness
Cadence Pro for SC
INSTALL
MANUAL

Advertisement

loading

Related Manuals for Schwinn Cadence Pro

Summary of Contents for Schwinn Cadence Pro

  • Page 1 Core Health & Fitness Cadence Pro for SC INSTALL MANUAL...
  • Page 2 Pair Sensor + Computer Begin with one battery removed from the com- puter. Insert the battery while pressing and holding any of the four buttons on the front of the comput- er. The display will now show the maintenance screen. Press the Set button ( ) and“CAD”...
  • Page 3 To pair automatically, press the Mode button( The 4-digit alpha-numeric code should match the code on the side of the cadence transmitter and the back of the computer If needed, a manual pairing can be done by press- ing and holding the Mode button ( ).
  • Page 4 Press the Set button ( ) to fi nish and begin exercise. NOTE: Once the pairing has been completed, the code is stored in the on-board memory so that the code is retained during a battery change, avoiding the need to re-pair.

  • Page 5: Tools Required

    SC5 + SC7 Tools Required: • 3mm Allen Key • #2 Phillips Screwdriver Install the silicone seal onto the back of the Ca- dence Pro computer. Ensure that the holes in the seal line up with the screw holes of the computer. Use a #3mm allen key to secure the back plate of the mount to the computer using three (3) M5 x 10mm screws.
  • Page 6 Mount the magnet on the user right crank arm approximately where shown. Do not secure the magnet in place yet at this point with the mag- net holder. Only secure the magnet in place once the magnet and sensor positions have been set in close enough proximity to verify that the comput- er is displaying an RPM reading - See Step 8.
  • Page 7 Stick the RPM sensor, battery side out, onto the user right side chain/belt guard where shown. Verify that the sensor is communicating with the computer and reading RPMs by spinning the crank arms. Adjust the position of the magnet on the user right crank arm if needed.
  • Page 8 © 2018 CORE HEALTH & FITNESS, LLC PART NUMBER 620-8695, REV A...