Schwinn Cadence Pro Install Manual page 6

4. Mount the magnet on the user right crank arm
approximately where shown. Do not secure the
magnet in place yet at this point with the mag-
net holder. Only secure the magnet in place once
the magnet and sensor positions have been set in
close enough proximity to verify that the comput-
er is displaying an RPM reading - See Step 8.
NOTE: There are two sizes of magnets included in the
kit. One is 5mm thick and one is 3mm thick. Depend-
ing on the model of bike and the amount of clearance
between the crank arm and chain/belt guard, install
may require the use of the thinner 3mm magnet.
5. Use a #2 phillips screwdriver to remove the left
side chain/belt guard.
6. Install the RPM sensor into the foam mounting
block then remove the backing.
Page 5