Using The Detachable Front Panel - Caliber RCD 263BT Manual

2. DIN REAR-MOUNT (Method B)
If your vehicle is a Nissan, Toyota, follow
this mounting instruction. Use the screw
holes marked T (Toyota), N (Nissan)
located on both sides of the unit to fasten
the unit to the factory radio mounting
brackets supplied with your vehicle.
Fasten the unit to the factory radio
mounting brackets. Align the screw holes
on the bracket with the screw holes on the
unit, and then tighten the screws (5x5mm)
on each side.
Note: the outer trim ring, sleeve and the
metal strap are not used for method B
installation.

Using the detachable front panel

Using the detachable front panel
Removing and protecting detachable
front panel
The front panel of the unit may be removed
as a theft deterrent. After removing the
front panel, use the case provided to keep
the front panel from getting damaged.
.
1 Press the Release button ( ) to flip down
the front panel.
.
2 Pull off the front panel
.
3 Store the front panel in the protective
case provided for safekeeping
protective case
front panel
TO ATTACH THE FRONT PANEL
To install the front panel, insert the panel
into the housing and make sure the panel is
properly installed. Otherwise, abnormality
occurs on the display or some keys will not
function properly.
Release button
.
.
front panel