Advertisement
5.
Exit programming mode by pressing and holding the # key until you hear the double
beep.
For recording user PIN codes when the WSSKP-1 is configured for standalone operation
only, use the table on page 14.
Restore Factory Default Settings / Clear PINs
Use the following code selections for restoring default settings:
2 + 0 Keys – Restore Default Settings
6 + 4 Keys – Clears All PIN Numbers
Refer to the following sub-headings to restore or clear applicable settings.
Steps to Restore Factory Default Settings
This procedure restores all codes to their default values excluding user PIN codes 8 to 62.
1.
Power down the WSSKP-1 keypad.
2.
Press and hold the 2 key and the 0 (zero) key simultaneously and apply power to the
keypad and wait until you hear a double beep.
3.
Enter the default master code - 9571. You will hear three (3) beeps.
4.
To clear all the PIN codes, go to Steps to Clear All PINs. Otherwise go to the next
step.
5.
Exit by pressing the # key. You will hear a double beep.
The factory default settings have now been restored.
Steps to Clear All PINs
This feature clears all 28 user PIN numbers assigned under Codes 8 to 64. It does not
affect any other code settings.
1.
Press the * (star) key.
2.
Press and hold the 6 key and the 4 key simultaneously until you hear a double beep.
3.
Press the # key. The user PINs have been cleared.
WSSKP-1 Installation & Programming Guide
13
Hide quick links:
Advertisement
