Installing The Software (Download); Downloading The Startup Code - Siemens SIMATIC S7-1200 Manual

6 Installation and Commissioning

6.2 Installing the software (download)

6.2 Installing the software (download)
This chapter describes the steps for installing the sample code.
Note At this point, it is assumed that the necessary software has been installed on
your computer and that you are familiar with the software.
Preliminary remark
For the startup, we offer you software examples with test code and test parameters
as a download. The software examples support you during the first steps and tests
with set 6. They enable a quick test of hardware and software interfaces between
the products described in the set.
The software examples are always assigned to the components used in the set
and show their basic interaction. However, they are not real applications in the
sense of a technological problem solution with definable properties.
6.3

Downloading the startup code

The software examples are available on the HTML page from which you
downloaded this document.
Downloading the TIA Portal project
Table 6-2
No.
1. Unzip and open the project from
TIA Portal V14.
Select the "PLC_1" control project folder and
2.
confirm the button for loading the CPU.
Select the project folder for the "HMI_1" operator
3.
panel and click the button to load it into the Comfort
Panel.
Alternatively, you can simulate the TP700 Comfort
operator panel also without hardware via the TIA
Portal.
Weighing, Controlling and Logging (Set 6)
Entry ID: 82454336, V2.0,
Action
Table 2-4 using
10/2017
Comment
42