Advertisement
QS WM Under shelf Light
HARDWARE KIT QS-HWR048
Step 1
Carefully remove the plastic diffuser to expose the inside of the light housing. Align the slots in the light
housing over the inserts in the underside of the instrument shelf. Thread 2 each 1/4-20 x 5/8" phillips screws
with 1/4" washers in the inserts in the shelf and tighten. Install the appropriate light tube. It is a good idea to
test the light at this time by plugging it in and turning it on and off. If the light tube does not light please double
check that the power is on and the tube is good. Once the light tube works carefully replace the plastic
diffuser taking care not to force it into place as this could cause it to break.
Note:
This SIL UNDERSHELF light fixtures are designed to run with high efficiency T8 Tubes
A F32T8 SP41 is shown for reference only. Brand name is also reference only.
9
Advertisement
