Related Manuals for IAC INDUSTRIES 960
Summary of Contents for IAC INDUSTRIES 960
- Page 1 INDUSTRIES 960 Motorized Adjustable Bench IAC INDUSTRIES 3831 S BULLARD AVE., GOODYEAR, AZ 85338 Phone (714) 990-8997 Fax (714) 990-0557 www.iacindustries.com 960 Motorized ADJ. HI Assembly Instructions REV. (042318P65)
-
Page 2: Attention Notes
Industries customer service at 800-989-1422. WARNING: ALL PARTICLE BOARD USED IN IAC INDUSTRIES PRODUCTS ARE SOURCED ONLY FROM VENDORS THAT ARE CARB ATCM PHASE 2 AND TSCA TITLE VI COMPLIANT WITH VALID CERTIFICATES Drilling, Sawing, Sanding or Machining Wood products can expose you to wood dust, a substance known to the state of California to cause cancer. - Page 3 Step 1: With Accessories installed, Press the Remote “UP” button and between mid-point to highest point, check to see if the top moves back and forth when the work surface is pushed (there will be some play, but it should be minimum) Step 2: If top is stable, your top will not need any adjustments made.
- Page 4 960 Bench Assembly Drawing 48 Long (Figure 1)
- Page 5 960 Bench Assembly Drawing (Figure 2)
-
Page 6: Item Description
Parts List: 960 Motorized Adjustable Bench (Ref. Figure 1&2) Item Description Qty. Item Description Qty. Work surface (STD. or ESD) Screw, 10-32x1.00” PPH 960 Leg Sub-Assy-RT & LT ea Screw, #6x .50 PPH/SMS Front Support Beam 1.5"H Tie Mount, Plastic Std. - Page 7 Assembly Instructions (Continued) …………… Attach motorized pump system’s switch to front support beam (item 3) as shown below using 10-32x 1.00” pan phillips head screw (item E) with well nut 10-32 (item J) and 5/16 flat washer (item D) two places. While the bench is upside-down plug the motor system into a power source and raise the leg assemblies to their highest point.
- Page 8 ESD GROUNDING: HWR-014 ESD Hardware Kit ESD refers to the OPTIONAL static dissipative laminate used on the bench. The laminate has a conductive under layer that comes in contact with the factory installed grounding bolts in the worksurface. The ESD grounding kit, including the 10 ft. grounding wire must be attached and the bench must be properly grounded to your facility earth ground.
-
Page 9: Grounding Cautions
GROUNDING CAUTIONS: 1.) Ground each bench individually to ground, NEVER to each other in a continuous daisy chain. 2.) ISOLATED ground receptacles should not be used to derive an ESD ground. 3.) The green wire in a standard wall duplex can be used as a ground if it has been absolutely determined that the green wire is attached to earth ground in your facility, thereby providing a real earth ground.