Advertisement
QS Workmaster Bench Assembly: (cont)
Step 3:
Align the workbench pedestals over the ends of the support beams and lower them down over the beam
connector plates so that the plates are on the inside of the pedestal tubing. Align the slots in the pedestal
support beam over the inserts in the worksurface and thread the 1/4-20 x .75 HH bolts with the 1/4 washers
into the inserts. Tighten the beam connector hardware. The frame should now be aligned on the worksurface
to even the overhangs on the right and left sides Tighten the beam attachment and the pedestal support
beam hardware. NOTE: Do not over tighten the hardware that goes into the threaded inserts in the
worksurface as this could cause the insert to pull out.
Step 4:
Slide the workbench leg extender into the pedestal tube making sure the plastic insert in the end of the leg
extender is exposed. Align the threads of the leg extender with the holes in the pedestal tube and select the
desired height of the bench. Thread the 1/4-20 x .75 HH bolts with the 1/4 washers into the threaded holes in
the leg extender and tighten. Thread the floor glide into the plastic insert of the leg extender. The floor glides
are used to level the bench when assembly is complete and it is put into position.
If you have ordered footrests, drawers or suspended cabinets for this bench please see pages 10 and 12 for
assembly instructions. If not the workbench can be turned over for assembly of above the worksurface
accessories or it can be put into place.
6
Advertisement
