Related Manuals for IAC INDUSTRIES 930
Summary of Contents for IAC INDUSTRIES 930
- Page 1 INDUSTRIES 930 Hand Crank Adjustable Bench IAC INDUSTRIES 3831 S BULLARD AVE., GOODYEAR, AZ 85338 Phone (714) 990-8997 Fax (714) 990-0557 www.iacindustries.com 930 HAND CRANK ADJ. HI Assembly Instructions REV. (042318P65)
-
Page 2: Attention Notes
If you believe there are parts missing from your order please contact IAC Industries customer service at 800-989-1422. WARNING: ALL PARTICLE BOARD USED IN IAC INDUSTRIES PRODUCTS ARE SOURCED ONLY FROM VENDORS THAT ARE CARB ATCM PHASE 2 AND TSCA TITLE VI COMPLIANT WITH VALID CERTIFICATES Drilling, Sawing, Sanding or Machining Wood products can expose you to wood dust, a substance known to the state of California to cause cancer. - Page 3 930 Bench Assembly Drawing (Figure 1)
-
Page 4: Item Description
Parts List: 930 Hand Crank Adjustable Bench (Ref. Figure 1) Hardware Kit – HWR461* Item Description Qty. Item Description Qty. Worksurface Screw, 10-32x 3.00L PHP 930 Leg Sub-Assy-Rt & Lt Washer, # 10 Flat Zinc Front Support Beam 1.5H Nut, #10-32 Hex Keps 930 Modesty Panel Cap, 2.00”... - Page 5 Loosely attach one end of the modesty panel (item 4) to one end of the leg assemblies (item 2) by aligning up the three 1/4-20 x .75 SQ. Head GR2 Bolt (item D) into the modesty panel (item 4) holes and attaching that end using the a 1/4 flat washers (item B) and a 1/4- 20 Hex Keps nut (item C) for each of the three bolts.
- Page 6 Figure 2...
-
Page 7: Grounding Cautions
ESD GROUNDING: HWR-014 ESD Hardware Kit ESD refers to the OPTIONAL static dissipative laminate used on the bench. The laminate has a conductive under layer that comes in contact with the factory installed grounding bolts in the worksurface. The ESD grounding kit, including the 10 ft. grounding wire must be attached and the bench must be properly grounded to your facility earth ground. - Page 8 Grounding Cautions (Continued) ………….. 5.) DON’T use power tools to install the nuts for the grounding kit. HAND TIGHTEN ONLY. If you attempt to 'spin' the ground bolt, the serrated teeth under the head of the bolt might strip the thin conductive layer.