infaco A3M V2.0 Instructions For Using Manual page 20

AT THE END OF THE REEL, SOME WIRE IS STUCK IN THE TYING HEAD
Pivot tying head 01 90° to gain access
to screw 02.
01
02
Take hold of tying head 01 and pull it
to remove it from the body 02 of the
machine.
01
02
Before you put the head back on, we
recommend lubricating the shaft with
guide pin 01.
Use key 01 to loosen screw 02 by ap-
proximately 4 or 5 turns.
To avoid the risk of losing screw 02, we
recommend that you do not unscrew it
completely.
Once you have disconnected the
tying
reel wire 01 from the tying head.
You can also take the opportunity to in-
sert the new wire, as it will be easier to
thread through.
01
Put the tying head back on, positioning
guide pin 01 opposite its housing. Then
tighten screw 02 to complete the ope-
ration.
01
20
head, remove
01
02
01
the end-of-
02