Summary of Contents for SKF Lincoln PowerLuber B Series
Page 1
Installation and maintenance guide PowerLuber grease gun Models AC2400 and AC2440, series “B” April 2014 Date of issue D A N G E R Form number 404575 Read manual prior to installation or use Section of this product. Keep manual nearby for Page future reference.
General power tool Table of contents 2.4 Do not abuse the cord. Never use the safety warnings cord for carrying, pulling or unplugging the power tool. Keep cord General power tool away from heat, oil, sharp edges or safety warnings ....moving parts.
Page 3
3.4 Remove any adjusting key or wrench 4.6 Keep cutting tools sharp and clean. Notice before turning the power tool on. Properly maintained cutting tools Do not dispose of product with A wrench or a key left attached to a with sharp cutting edges are less normal household waste.
Tool use and care Service Notice Grease cartridges are not • Do not use the PowerLuber if the switch • Service must be performed only by included in this product. does not turn it on and off. A PowerLuber qualified repair personnel. Service or that cannot be controlled with the switch maintenance performed by unqualified is dangerous and must be repaired.
General description Inspection Variable output switch The variable speed switch permits motor Appropriate use speed control, the more the trigger is 1 Visually inspect for damaged, loose or The Lincoln PowerLuber was developed for depressed the higher speed of the motor missing parts.
Page 6
Fig. 1 Vent Bulk valve valve High/low output sensor Stroke counter Relief valve discharge hole Relief valve 1230 30 in. (762 mm) hose 5852 Coupler with cap Power cord 6 ft. (1,8 m long)
Page 7
Install grease Convert gun to allow Fill gun from bulk cartridge filling from bulk container container or filler 1 Unscrew the grease tube assembly from 1 Remove pump assembly from grease the PowerLuber. tube assembly. pump 2 Visually check the follower seal lip 2 Pack lubricant into cavity of the pump direction before loading a new cartridge.
Page 8
Fill gun with a filler Notice pump Remove air pocket! Air pocket at grease inlet will prevent grease from 1 Engage the follower rod with the follower being pumped. Unscrew the vent/bulk by rotating the follower handle. fill valve two full turns to remove small 2 Insert the gun vent/bulk fill valve into the air pockets trapped in this area.
Troubleshooting Condition Possible cause Corrective action Motor fails to run. No power Check power cord connection with outlet. Loose wire connection. Disassemble handle and check wiring for loose connection. Faulty switch. Replace switch. Worn motor brushes. Replace motor. Burned motor. Replace motor.
Page 13
Lincoln industrial Special limited 5 year warranty– This warranty gives you specific legal limited oil meters, limited fluid control standard warranty rights. You may also have other rights that valves, aod (air-operated diaphragm vary by jurisdiction. pumps) Customers not located in the Western Standard limited warranty Hemisphere or East Asia: Please contact Lincoln warrants the 712 series control...
Page 16
Every care has been taken to ensure the accuracy of the information contained in this publication but no liability can be accepted for any loss or damage whether direct, indirect or consequential arising out of the use of the information contained herein. SKF PUB LS/I4 14612 EN.R1 · April 2014 · Form 404575 lincolnindustrial.com...
Need help?
Do you have a question about the Lincoln PowerLuber B Series and is the answer not in the manual?
Questions and answers