Connecting To The Virtual Servers - TRENDnet TEW-435BRM User Manual

802.11g wireless adsl router, 802.11g/802.11b wireless access point, adsl modem, nat router, 4-port switching hub

Hide thumbs Also See for TEW-435BRM:

Table of Contents

Wireless ADSL Router User Guide

Data - Virtual Servers Screen

Servers

Properties

Enable

PC (Server)

Connecting to the Virtual Servers

Once configured, anyone on the Internet can connect to your Virtual Servers. They must use

the Internet IP Address (the IP Address allocated to you by your ISP).

e.g.

http://203.70.212.52

ftp://203.70.212.52

It is more convenient if you are using a Fixed IP Address from your ISP, rather than Dynamic.

However, you can use the Dynamic DNS feature to allow users to connect to your Virtual

Servers using a URL, rather than an IP Address.

Figure 38: Virtual Servers Screen

This lists a number of common Server types. If the desired Server

type is not listed, you can create a Firewall Rule to achieve the

same effect as the Virtual Server function.

Use this to Enable or Disable support for this Server, as required.

If Enabled, you must select the PC to which this traffic will be sent.

Select the PC for this Server. The PC must be running the appro-

priate Server software.

For each entry, the PC must be running the appropri-

ate Server software.

If the desired Server type is not listed, you can define

your own Servers, using the Firewall Rules.

From the Internet, ALL Virtual Servers have

the IP Address allocated by your ISP

Table of Contents