Safety Regulations For The Owner/Operator; Safety Regulations For Maintenance, Inspection And Installation Work; Unilateral Modification And Spare Parts Manufacturing; Unproved Usage - Conel FLOW CUT BOX Installation And Operation Instruction Manual

Safety Regulations | Unilateral modification and spare parts manufacturing | Unproved usage |

Scope of delivery

4.4 Safety Regulations for maintenance, inspection and
installation work
The user of the unit should ensure that all maintenance, inspection or installation
work is carried out by authorised and qualified skilled personnel. The user must
also make certain that they have carefully studied the operating instructions.
In principle all work on the unit should only be carried out while it is stationary.
Pumps or units, used for pumping or fluids which could be injurious to health must
be decontaminated. After completion of the work all safety and protective devices
must be refitted and a check should be made that they are fully functional.
Before starting up again, the points listed under the section "Commissioning" should
be complied with.

4.5 Unilateral modification and spare parts manufacturing

Modifications or changes to the unit/installation should only be carried out after
consultations with the manufacturer. Original spare parts and accessories autho-rised
by the manufacturer are essential for compliance with safety requirements.
The use of other parts can invalidate any claims for warranty or compensation.

4.6 Unproved usage

The operating safety of the unit is only guaranteed provided that the unit is used
in accordance with these operation instructions. The limit values given in the data
sheet should under no circumstance be exceeded. These installation and operation
instructions do not supersede or exclude the following of generally valid regulations
and standards.
5. Scope of delivery
Synthetic tank, pre-assembled and wired, ready for installation with rubber feet, tank
mounting supports/securing brackets, inlet seals, non-return valve for external
attachment, overflow protection and alarm, vent with integrated odour filter, built-in
motor unit with shredding system and moisture sensor level control.
Please note that the seal with part-number 43075164 for the connection of a separate
vent line is included as an accessory (see point 16).
31