Sony DWR-R03D Operating Instructions Manual page 19

5
Set the encrypted transmission function on the
transmitter to PASSWORD.
6
On the transmitter, set the same password that was set
on the receiver.
For details on transmitter operations, refer to the
operating instructions supplied with the transmitter.
Note
It is recommended that you change the password
periodically.
Setting the Audio Codec
Mode
This receiver has four audio codec modes. Switch
between them based on your operational needs.
MODE1: Audio codec mode that is compatible with first
generation DWX-series devices.
MODE2: Audio codec mode that prioritizes short delay
times while maintaining transmission stability and high
audio quality.
MODE3: Audio codec mode that uses additional signal
processing to suppress noise caused by unexpected pulse
interference.
MODE4: Audio codec mode that prioritizes audio
quality for faithful reproduction while maintaining
transmission stability and low delay time.
Note
The audio delay time of the transmitted/received signal in
each mode will vary depending on the transmitter usage
environment.
For details, see "Audio Codec Mode Setting (CODEC
MODE)" (page 22).
1
Press the RX button to select the RECEIVER menu.
2
Rotate the jog dial to move the cursor to the CODEC
MODE indication, and then press the dial.
3
Rotate the jog dial to move the cursor to the audio
codec mode indication that you want to select, and
then press the dial.
If there is a transmitter paired with this receiver at that
time, the audio codec mode of the transmitter is also
switched at the same time.
19