Sony DWR-R03D Operating Instructions Manual page 26

Notes
• When you set the wireless remote control function to
ON, the transmitter will communicate with the receiver
to which it was previously paired. To use the RF
REMOTE function with another transmitter, you must
perform the pairing procedure again for that transmitter.
• Pairing with multiple transmitters is not possible.
• Even if pairing was performed in an ST remote system,
pairing needs to be performed again to use the wireless
remote control in an NT remote system.
The following transmitter settings can be
performed when pairing is established:
• Frequency band/group/channel selection
• Transmitter name setting
• Power save setting
• RF transmission power setting
• Audio input level setting
• Attenuator setting
• Low-cut filter setting
• +48V setting
• Resetting accumulated transmitter use time
• Audio codec mode setting
• Internal signal setting
• Lock setting
• Remaining battery capacity display mode setting
For details on the transmitter settings, see "Changing the
Settings on the Transmitter" (page 31).
Cancelling the Cross Remote
In the RF REMOTE menu, select RF REMOTE, and then
select OFF.
Notes on the Cross Remote
The wireless remote control function on the receiver uses
the 2.4 GHz band and may thus be subject to interference
from other devices.
• When pairing fails ("PAIRING FAIL" is displayed),
carry out pairing again.
Successful communication between the transmitter and
the receiver has not occurred within a given amount of
time.
Pairing may be harder to do when another receiver is
engaged in pairing nearby.
• When it becomes hard to use the remote control, the
remote control may be improved by switching the RF
REMOTE function off, then on again, and then re-
pairing with the transmitter (change to a channel with
less interference).
Displaying the Remote Mode
Display whether the receiver is operating in the ST
remote or NT remote mode. (The mode can only be
displayed.)
NT: The receiver has recognized the RMU-01 unit and is
operating in NT remote mode.
ST: The receiver is operating in ST remote mode.
SEARCH: The receiver is searching for the remote mode
state.
(MODE)
26