I Installing The Sensors On The Pod Kit - Zodiac eXO iQ 10 Instructions For Installation And Use Manual

3.4 I Installing the sensors on the POD kit

• Screw the one or more threaded sensor holders onto the POD kit, see fi gure
• Carefully unscrew the protecti on tube from the sensor, see fi gure
the sensor over winter.
• Rinse the end of the sensor with tap water and shake off excess water, see fi gure
• Never wipe the sensor using a cloth or paper ti ssue, as this may damage it.
• A badly-installed sensor may give false readings and cause inappropriate operati on of the
appliance. Neither the manufacturer nor the appliance shall be liable in this event.
• Screw the sensor into the sensor holder by holding the BLUE or YELLOW ti p in one hand and the black ti p
in the other hand to prevent the cable from tangling, see fi gure
• Once the sensor has been installed on the POD kit, it can be connected to the BNC socket (BLUE = pH;
YELLOW = ORP) of the pH Link or Dual Link module, see "2.5.3 Electrical connecti on steps", see fi gure
• The sensor must then be calibrated, see "5.3 I Calibrati ng the sensors (if an opti onal "pH Link" or "Dual
Link" module has been installed)"
24
.
. Keep the protecti on tube for storing
.
.
.