Setting Disk Slot Associations - Sun Microsystems Ultra 450 Manual

Setting Disk Slot Associations

Perform the following procedure after you complete the hardware installation of the
8-bay storage expansion kits:
1. Power on the system.
See "How to Power On the System" in the Sun Ultra 450 Workstation Owner's
Guide or Ultra Enterprise 450 Server Owner's Guide.
2. When the system banner is displayed on the monitor, press Stop-a on the Sun
keyboard.
If you are using an alphanumeric terminal instead of a monitor, press the Break
key on the terminal's keyboard.
3. When the ok prompt is displayed, enter the following command:
ok setenv disk-led-assoc 0 x y
where:
4 x is an integer between 1 and 10 identifying the rear panel PCI slot number
4 y is an integer between 1 and 10 identifying the rear panel PCI slot number
For example, if the controller cards are installed in PCI slots 5 and 7, enter the
following:
ok setenv disk-led-assoc 0 5 7
For a system with only one controller card installed in PCI slot 2, enter the following:
ok setenv disk-led-assoc 0 2
1. Enter the following command at the ok prompt:
ok reset
2. When the system banner is displayed on the monitor, press Stop-a on the Sun
keyboard.
If you are using an alphanumeric terminal instead of a monitor, press the Break
key on the terminal's keyboard.
♦ September 1998, Revision A
2
where the lower UltraSCSI controller is installed
where the upper UltraSCSI controller is installed