Table of Contents
Advertisement
Available languages
Available languages
10 REPLACING THE OVEN DOOR
NOTE: The oven door is heavy. You may need help
lifting the door high enough to slide it into the hinge
slots. Do not lift the door by the handle.
A. Lift the oven door by grasping
each side.
B. With the door at the same
angle as the removal position
(approximately 1"–2" [2.5 cm–5.1
cm] from the closed position),
seat the notch of the hinge arm
into the bottom edge of the hinge
slot. The notch of the hinge arm
must be fully seated into the
bottom of the slot.
C. Fully open the door. If the door will not fully open,
the indentation is not seated correctly in the bottom
edge of the slot.
D. Push the hinge locks up against the front frame of
the oven cavity, to the locked position.
Hinge in
Locked
Position
Notch of Hinge
Securely Fitted
Into Bottom of
Hinge Slot
E. Replace hinge bracket, if
equipped, to ensure proper door
functionality.
F. Close the oven door.
31-2000693 Rev. 0
Installation Instructions
Hinge
Bottom
Arm
Edge of
Slot
Hinge Notch
Hinge Bracket
11 FINAL INSTALLATION
CHECKLIST
(RESET) or the circuit fuses are replaced.
been removed. Failure to remove these materials
could result in damage to the appliance once the
appliance has been turned on and surfaces have
heated.
installed and flush with the side trim (see Section 9).
installation instructions and check that both ends are
secured.
OPERATION CHECKLIST
Turn power on at the source. The interior light
should come on when the door is opened.
When power is applied to the unit for the first time,
the control will go through an initial setup. These
settings can be changed at any time. Reference the
SETTINGS section. During this initial setup, use the
arrow keys and SELECT keypad to follow the oven
control prompts.
See your Owner's Manual for the operating
instructions troubleshooting list.
Be sure all of the oven controls are OFF before
leaving the oven.
13
Advertisement
Table of Contents
