Table of Contents
Advertisement
9
7 7 7 7
"
"
"
"
A #
A #
A #
A #
The Knife Assembly is attached to the Rear Paper Cover of the printer.
1.
Disconnect the knife harness connector and unroute the wires from the wire retention clips.
2.
Unscrew the self-tapping, "middle screw", to release the knife assembly from the rear paper compartment cover.
3.
Unsnap the knife assembly from the the rear paper cover.
Figure 9 Removing Knife Assembly from the Paper Cover
) *
) *
) *
) *
Revision J
Advertisement
Table of Contents
