Initializing Your Wired Remote Controller Communication; Errors Displayed On The Wired Remote Controller - Samsung MWR-WG00UN Installation Manual

Wired Remote Controller Installation Wired Remote Controller Installation

Initializing Your Wired Remote Controller Communication

Wired remote controller must be initialized if installation status changes.
Changing number of ventilator (ERV)/indoor unit or their address
1 Press the and
Your Wired Remote Controller will be initialized, and the device will search for the indoor units/
ventilator(ERV) connected to your Wired Remote Controller again.

Errors displayed on the Wired Remote Controller

Error codes for the Wired Remote Controller and the product connected to your Wired Remote Controller will be
displayed in the LCD display.
Wired Remote Controller error codes
Indication
Communication error between wired remote controller and indoor/ERV units after
successful communication. (communication stop for 3 minutes after detection)
Controllers. (communication stop for 3 minutes after detection)
When tracking between the Wired Remote Controller and indoor units/ventilators
(ERV) is not complete for more than 5 minutes (Including communication error
between indoor units and outdoor units)
Over 16 indoor units and ventilators (ERV) installed.
Reset is required after checking the number of installed indoor units and
ventilators (ERV).
Temperature sensor Open/Short error
NOTE
For the error codes for your indoor/outdoor units and ventilator(ERV), refer to the installation manual of each
device.
16 English
buttons at the same time for more than 5 seconds.
Description Remarks
Can be detected by
the product with
a temperature
sensor.