Samsung MWR-WG00UN Installation Manual page 8

5 Reassemble the Wired Remote Controller.
NOTE
Align the controller with the upper groove first, and then insert it by
turning it downwards as shown in the figure.
After assembly, check and confirm that no wires are stuck in the gap
between the back and front covers.
6 Remove the front protective film.
CAUTION
communication cable and the power cable separately. (Electrical interference can cause the Wired Remote
Controller to malfunction.)
When installing your Wired Remote Controller on the wall, consider the size of the wire hole, and select a wire
with a proper thickness.
Wire that is connectable to Wired Remote Controller PCB.
If you install the Wired Remote Controller by reclaiming, install it according to U-terminal cable specification.
sheath of the cable and install it only with the two pieces of wires. (Recommended specification: AWG20)
English 7