Initializing Your Wired Remote Controller Communication; Errors Displayed On The Wired Remote Controller - Samsung MWR-WW10N Installation Manual

Wired Remote Controller Installation Wired Remote Controller Installation

Initializing Your Wired Remote Controller Communication

Wired remote controller must be initialized if installation status changes.
Changing number of indoor unit or their address
1 Press the and
Your Wired Remote Controller will be initialized, and the device will search for the indoor units connected to
your Wired Remote Controller again.

Errors displayed on the Wired Remote Controller

Error codes for the Wired Remote Controller and the product connected to your Wired Remote Controller will be
displayed in the LCD display.
Wired Remote Controller error codes
Display
Communication error between remote controller and the Hydro unit/Hydro unit HT
Communication error between master and slave remote controller
Tracking error between remote controller and the Hydro unit/Hydro unit HT
Error due to exceeding maximum numbers of Hydro unit installation (16 units)
Error caused by installing mixed models
Remote controller's temperature sensor is disconnected or has problem
14 English
buttons at the same time for more than 5 seconds.
Contents