Temperature Setting Guide; Steam Ironing; Spray; Shot Of Steam - Russell Hobbs SLIDE FILL GO SMARTFILL 21262 Instructions Manual

TEMPERATURE SETTING GUIDE

Label mark
j cool – nylon, acrylics, polyester
k warm – wool, polyester mixtures
l hot – cotton, linen
i
Do not iron
If the instructions on the fabric label differ from this guide, follow the instructions on the label.

STEAM IRONING

If you intend to use steam, the temperature setting must be S or higher.
1.
Set the steam control to the setting you want (S = no steam, # = high).
2.
3. Wait till the light goes off, then start ironing.

SPRAY

Water spotting affects some fabrics. Test this on a hidden part of the fabric.
1. Lift the iron off the fabric.
2. Aim the spray nozzle at the fabric.
Press the * button.
3.
4. You may have to press it 2 or 3 times to pump water through the system.

SHOT OF STEAM

If you intend to use steam, the temperature setting must be S or higher.
1.
2. Lift the iron off the fabric.
Press the ~ button.
3.
4. Leave 4 seconds between shots, to let the steam build up.

DRY IRONING

If you're going to be dry ironing for 20 minutes or more, empty the reservoir first, to avoid
spontaneous bursts of steam.
1. Set the steam control to S.
2. Wait till the light goes off, then start ironing.

VERTICAL STEAMING

1. Remove wrinkles from hanging clothes, hanging curtains, and furnishing fabrics.
2. Check that there is adequate ventilation behind the fabric, otherwise moisture may build
up, causing mildew.
3. Check that there is nothing behind the fabric that may be damaged by the steam.
4. Check that pockets, turn-ups, and cuffs are empty.
5. Set the temperature control to max. Set the steam control to S.
6. Lift the iron off the fabric.
Press the ~ button.
7.
8. Leave 4 seconds between shots, to let the steam build up.
Temperature dot setting
5
•
••
•••/max