Temperature Setting Guide; Steam Ironing - Russell Hobbs Autosteam Ultra Instructions Manual

temperature setting guide

label marking
j cool – nylon, acrylics, polyester
k warm – wool, polyester mixtures
l hot – cotton, linen
i do not iron
, If the instructions on the fabric label differ from this guide, follow the instructions
on the label.
X FILLING
3 Move the p switch to 0.
4 Move the r switch to 0.
5 Unplug the appliance.
6 You may remove the reservoir and fill it from a tap, or leave it in place, and fill it from
a jug.
7 Grip the bottom front of the reservoir
8 Pull the reservoir out of the base unit
9 Open the cover.
10 Fill the reservoir to the MAX mark.
11 Don't add anything to the water – you'll damage the iron.
12 Close the cover.
13 Slide the reservoir into the base unit till the catch clicks into place.
C SWITCH ON
14 Set the temperature control to •.
15 Put the plug into the power socket.
16 Move the p switch to 1.
17 The switch will glow.
18 Move the r switch to 1.
19 The switch will glow.
20 When the boiler is ready to generate steam (2-3 minutes), the ~ light will glow.
21 It will then cycle on and off as the thermostat operates to maintain the temperature.
22 Turn the temperature control to bring the setting you want next to the thermostat
light.
23 The thermostat light will glow.
24 When the iron reaches the set temperature, the thermostat light will go off.
25 It will then cycle on and off as the thermostat operates to maintain the temperature.
h STEAM IRONING
, If you intend to use steam, the temperature setting must be S or higher.
26 Set the steam control to the setting you want (S = low, # = high).
27 Press the steam button to produce steam, release it to stop the steam.
28 For a constant stream of steam, press the steam button, then slide the latch (on the
rear of the button) back, towards the rear of the iron, to lock the button down.
29 Slide the latch forward, to unlock it, and revert to normal use.
temperature setting
•
••
•••/max
4