Temperature Setting Guide - Russell Hobbs Colour Control Pro 2400W Instructions Manual

• To switch on again, lift it up, tilt it forward, then sit it upright to return to operating
temperature.
• The temperature light will flash the colour appropriate to the current setting till it reaches
operating temperature
PREPARATION
Check for textile care symbols (i j k l).
1.
Iron fabrics needing low temperatures j first, then those that need medium
2.
temperatures k, and finish with those needing high temperatures l.

TEMPERATURE SETTING GUIDE

Label marking
j cool – nylon, acrylics, polyester
k warm – wool, polyester mixtures
l hot – cotton, linen
Max – denim
i do not iron
If the instructions on the fabric label differ from this guide, follow the instructions on the label.
FILLING
You may use the iron with tap-water, but if you live in a hard water area, you should use distilled
water (not chemically descaled or softened water).
If you buy distilled water, check that it's marketed as suitable for use in irons.
1. Unplug the iron.
2. Open the water inlet cover.
3. Hold the iron with the soleplate down.
4. Pour slowly, to let the air in the reservoir escape, otherwise you'll cause an air lock and the
water will overflow.
Don't fill past max, or water will escape in use.
5.
6. Wipe up any spillage.
SWITCH ON
1. Sit the iron on its heel.
2. Put the plug into the power socket (switch the socket on, if it's switchable). The iron will
beep and the light in the handle will come on yellow, to show it's in standby mode.
3. Press and release the temperature button to select the temperature you want.
4. The colour of the temperature light depends on the setting. The colours are:
Temperature light colour
Yellow
Blue
Purple
Green
Red
Dot setting
On - standby mode
4
Dot setting
•
••
•••
Max
-
•
••
•••
Max