Temperature Setting Guide - Russell Hobbs 21530 Instructions Manual

Extreme glide
Table of Contents

Advertisement

H Don't put the appliance in liquid, don't use it in a bathroom, near water, or outdoors.
7 Don't iron clothing while it's being worn – you'll injure the wearer.
8 Don't use the appliance for any purpose other than those described in these
instructions.
9 Don't scratch the soleplate – avoid buttons, zips, etc.
10 Don't wrap the cable round the appliance.
11 The appliance has a protective thermal fuse, which will blow if it overheats. If this
happens, the appliance will stop working, and must be returned for repair.
U BEFORE USING FOR THE FIRST TIME
• Remove labels, stickers and packaging from the iron and soleplate.
• Don't worry if the iron smokes a bit at first, it'll stop as the element cures.
• Iron an old piece of cotton fabric, to clean the soleplate.
• Press the ~ and * buttons 3 or 4 times, to check them.
C AUTO SHUT-OFF
• If the iron is motionless, it will switch off after about 30 seconds lying down, or
about 8 minutes if it's upright.
• It'll beep, and the power light will blink continuously till you move the iron.
• To switch on again, lift it up, tilt it forward, then sit it upright to return to operating
temperature.
• No settings are lost during auto shut-off.
C PREPARATION
1 Check for textile care symbols (i j k l).
2 Iron fabrics needing low temperatures j first, then those that need medium
temperatures k, and finish with those needing high temperatures l.
b TEMPERATURE SETTING GUIDE
label marking
j cool – nylon, acrylics, polyester
k warm – wool, polyester mixtures
l hot – cotton, linen
i do not iron
, If the instructions on the fabric label differ from this guide, follow the instructions
on the label.
X FILLING
3 You may use the iron with tap-water, but if you live in a hard water area, you should
use distilled water (not chemically descaled or softened water).
4 If you buy distilled water, check that it's marketed as suitable for use in irons.
5 Unplug the iron.
6 Set the temperature control to •, set the steam control to S.
7 Lift the top of the water inlet cover to open it.
8 Tilt the iron till the soleplate is at an angle of about 45°.
9 Pour slowly, to let the air in the reservoir escape, otherwise you'll cause an air lock
and the water will overflow.
10 Don't fill past max, or water will escape in use.
household use only
temperature dot setting
3
• •
• • •/max

Advertisement

Table of Contents
loading

Table of Contents