Avaya ERS 3500 Series Manual page 21

Electrostatic alert:
Risk of equipment damage
To prevent damage from electrostatic discharge, always wear an antistatic wrist strap
connected to an ESD jack.
Caution:
Risk of equipment damage
Only trained personnel can install this product.
About this task
Install an SFP to provide an interface between the device and the network cable.
Installing an SFP takes approximately three minutes.
Procedure
1. Remove the SFP from its protective packaging.
2. Grasp the SFP between your thumb and forefinger.
3. As shown in the following figure, insert the device into the slot on the module.
4. Remove the dust cover from the optical bore and insert the fiber optic connector.
Installing the SFP, SFP+, and XFP transceivers on Avaya ERS 3500 Series
Caution:
Risk of equipment damage
SFPs are keyed to prevent incorrect insertion. If the SFP resists pressure, do not
force it; turn it over, and reinsert it.
Apply a light pressure to the device until it clicks and locks into position.
Installing an SFP
March 2014 21