Toro 133-0150 Installation Instructions Manual page 8

1. Adjusting bolt
2. Locknut
3. Carriage bolt and flange
locknut (3/8 with 5/8 inch
hex)
5. Tighten the locknut on the HOC adjuster bolt,
then back off the locknut 1/2 turn
6. Center the front roller between the HOC bracket
assemblies and lock it in place with the cap
screws and flange nuts
8
Installing the Groomer
Drive Cap
Parts needed for this procedure:
1
Cap
Procedure
Only for Universal Groomer assemblies with no
rear roller brush kit installed:
1. Apply medium-strength cylindrical bonding
retaining compound (such as Green Loctite
609®) around the snap ring groove and the
outer diameter surface
Figure 13
4. Capscrew
5. Flange nut
(Figure
(Figure 13).
(Figure 14).
2. Install the cap as shown in
1. Cap
3. If you are installing the groomer at the left side of
the machine, perform the following
A. Remove the O-ring from the clutch knob.
B. Remove the shear pin that secures the
clutch knob to the actuator shaft.
g192299
C. Remove the clutch-knob assembly and flip
it over.
D. Assemble the clutch knob to the actuator
shaft with the shear pin.
E. Install the O-ring into the groove in the
clutch knob.
13).
1. Shear pin
2. Clutch-knob assembly
8
Figure
Figure 14
2. Apply Green Loctite 609®
Figure 15
Left-side install shown
3. O-ring
14.
g242099
(Figure 15):
g246113