Advertisement
Figure 27
1. Adjuster pin
2. Cotter pin
4.
Restrain the reel for removal; refer to
the Reel for Removing Threaded Inserts (page
18).
5.
Install the reinforcement screw (Part No.
1-803022—sold separately) to the internal
threads of the groomer drive hex head and
torque to 13.5 N⋅m (120 in-lbs) as shown in
Figure
27.
6.
Remove the groomer drive box from the cutting
reel by turning the groomer drive hex-head
(Figure
27).
Important:
If the groomer drive box is
installed on the right side of a cutting
unit, turn the groomer drive hex-head
counter-clockwise (right-hand thread) to
remove the drive-box shaft from cutting unit.
Important:
If the groomer drive box is
installed on the left side of a cutting unit,
turn the groomer drive hex-head clockwise
(left-hand thread) to remove drive-box shaft
from cutting unit
Important:
You must use a 6-point socket
with heavy wall.
g283882
3. Groomer drive hex-head
4. Reinforcement screw
Restraining
Cleaning the Grooming
Reel
Service Interval: After each use
Clean off the grooming reel after using it by spraying
it with water. Do not direct the water stream
directly at the groomer bearing seals. Do not permit
the grooming reel to stand in water so that the
components rust.
Inspecting the Blades
Service Interval: Before each use or daily
Inspect the grooming-reel blades frequently for
damage and wear. Straighten bent blades with a
pliers and replace worn blades. When inspecting the
blades, check to see that nuts on the right and left
blade-shaft ends are tight.
1. Grooming blade
2. Dull (rounded) edges
17
Figure 28
3. Sharp edges
g010613
Advertisement
