Toro 133-0150 Installation Instructions Manual page 4

Figure 4
1. Flange-head bolts
B. Install the 2 existing flange-head bolts from
the inside of the cutting unit, and secure
them with the 3/8 inch flange locknuts
(Figure 5).
Figure 5
1. Flange-head bolts
g037064
2. Support rod
g037065
2. Flange locknuts (3/8 inch)
5
Installing the Weight
Bracket and the Groomer
Drive Box
Parts needed for this procedure:
1 Weight bracket
2 Hex-socket, button-head bolt (3/8 x 3/4 inch)
1 Right (yellow) reel adapter
1 Left (green) reel adapter
1 Groomer drive box
Procedure
1. Apply medium-strength thread-locking
compound (such as Blue Loctite® 243) to the
threads on the inside of the drive shaft
6).
1. Internal threads; apply
thread-locking compound
here
2. Reel adapter—right side
2. Attach the appropriate reel adapter to the
groomer shaft
163 N∙m (110 to 120 ft-lb).
4
Figure 6
3. Reel adapter—left side
(Figure 6) and torque it to 150 to
(Figure
g199908