Advertisement
7
Installing the HOC Bracket
Assemblies and the Front
Roller
Parts needed for this procedure:
1
Left HOC bracket assembly
1
Right HOC bracket assembly
2
Adjuster pin
2
Cotter pin
2
Flange locknut (3/8 with 5/8 hex)
Procedure
1.
Loosely install the left and right HOC bracket
assemblies and the front roller assembly to the
cutting-unit side plates using the previously
removed carriage bolts
Figure 10
1. Right HOC bracket
assembly
2. Front roller assembly
3. Left HOC bracket
assembly
2.
On the groomer box side, slide the adjuster-arm
rod of the HOC bracket into the gap on the
groomer drive box and secure it with an adjuster
pin and cotter pin as shown in
Note:
The adjuster pin must be installed from
the inside of the machine to the outside of the
machine.
(Figure
10).
g232389
4. Washers
5. Carriage bolt and flange
locknut (3/8 with 5/8 hex)
Figure
11.
1. Adjuster pin
2. Adjuster-arm rod
3.
On the idler assembly side, align the
adjuster-arm rod of the HOC bracket with the
adjuster collar on the idler assembly and secure
it with an adjuster pin and cotter pin
1. Adjuster pin
2. Adjuster-arm rod
3. Adjuster collar
4.
Tighten the carriage bolts and locknuts securing
the HOC bracket assemblies to the side plates
(Figure
13).
7
Figure 11
3. Cotter pin
4. Groomer drive box
(Figure
Figure 12
4. Cotter pin
5. Idler assembly
g232400
12).
g232388
Advertisement
