Advertisement
Figure 17
1. Strap buckle
2. Retaining nut
3.
From 1 side of the groomer reel, slide a brush
into each groove around the full length of the
groomer reel
(Figure
Figure 18
22 inch groomer shown
1. Strap
2. Brush
4.
Verify that the brushes are seated in the groomer
blade slots
(Figure 17
3. Strap
4. Brush
18).
3. Toward rear of machine
and
Figure
19).
1. Brush
5.
Loosely wrap the straps, as shown in
17, around the groomer reel shaft and brushes,
inserting the straps in the grooves in the brushes
Figure
19.
Position the straps on the brushes using the
following table:
Reel Size
18 inch
g032403
22 inch
27 inch
Important:
the groomer blade and brush assembly in the
primary rotating direction.
the straps installed for forward rotation.
Note:
If the broomer brushes are not
seated properly in the blade slots, loosen the
groomer-blade retaining nuts on each end of the
groomer shaft, position the broomer brushes
properly in the blade slots, and tighten the
groomer-blade retaining nuts
6.
Tighten the groomer blade retaining nuts; torque
them to 45.2 N∙m (400 in-lb).
g227786
7.
While pushing a screwdriver against the strap
buckle, grasp each strap with a locking pliers
and pull the straps tight until they lock into the
brush grooves
8.
Trim the strap so that it is 6 mm (1/4 inch) from
the buckle and fold the excess strap over the
buckle.
10
Figure 19
2. Blade
Strap Spacing
Position the straps between
blades 2 and 3; 11 and 12; 21
and 22; and 30 and 31
Position the straps between
blades 2 and 3; 14 and 15; 26
and 27; and 38 and 39
Position the straps between
blades 2 and 3; 23 and 24 or
24 and 25; 35 and 36; and 45
and 46
You must wrap the straps around
Figure 18
(Figure
(Figure
17).
g032402
Figure
shows
17).
Advertisement
