Advertisement
iv
IMPORTANT WARNING AND SAFETY INSTRUCTIONS
Water temperature in excess of 100° F (37.7° C) may be hazardous to your health.
Prolonged immersion in hot water may induce hyperthermia. Hyperthermia occurs
when the internal temperature of the body reaches a level several degrees above normal
body temperature of 98.6° F (37° C.). Effects of hyperthermia include: (1) Unawareness
of impending danger. (2) Failure to perceive heat. (3) Failure to recognize the need to
leave the spa. (4) Physical inability to exit the spa. (5) Fetal damage in pregnant women.
(6) Unconsciousness resulting in danger of drowning. The use of alcohol, drugs, or
medication can greatly increase the risk of fatal hyperthermia in hot tubs and spas.
A pool or spa pump must be installed by a qualified pool and spa service professional in
accordance with the current National Electrical Code and all applicable local codes and
ordinances. Improper installation may create an electrical hazard which could result in
death or serious injury to pool users, installers, or others due to electrical shock, and may
also cause damage to property.
The use of alcohol, drugs, or medication can greatly increase the risk of fatal hyperthermia
in hot tubs and spas. This product is intended to control heaters with built-in high limit circuits
ONLY. Failure to do so may cause property damage or personal injury.
Do not use this product to control an automatic pool cover. Swimmers may become entrapped
underneath the cover.
For units intended for use in other than single-family dwellings, a clearly labeled
emergency switch shall be provided as part of the installation. The switch shall be readily
accessible to the occupants and shall be installed at least five (5) feet (1.52 m) away, adjacent
to, and within sight of, the unit.
Except for listed spa-side remote controls, install a minimum of five (5) feet (1.52 m) from the
inside wall of the pool and spa.
The electrical supply for this product must include a suitably rated switch or circuit breaker
to open all ungrounded supply conductors to comply with the current National Electrical
Code (NEC), NFPA 70 or the Canadian Electrical Code (CEC), CSA C22.1. All applicable
local installation codes and ordinances must also be adhered to. The disconnecting
means must be readily accessible to the tub occupant but installed at least five 5ft. (1.52
m), (Canada 3 m (9.75 ft) from the inside wall of the pool.
Use only copper supply conductor's rated for 60C/75C sized based on ampacity to
support all loads (refer to NEC tables). Load center input supply to be protected by
150 Amp Maximum, 240 VAC Main Circuit Breaker.
For information about the Virginia Graeme Baker Pool and Spa Safety Act, contact the Consumer Product Safety
Commission at (301) 504-7908 or visit www.cpsc.gov.
NOTE: Always turn off all power to the pool pump before installing the cover or working on any suction outlet.
Two Speed Pump Controls Notice (Title 20 Compliance)
Please read the following important Safety Instructions - When using two-speed pumps manufactured
on or after January 1, 2008, the pump's default circulation speed MUST be set to the LOWEST SPEED, with
a high speed override capability being for a temporary period not to exceed one normal cycle, or two hours,
whichever is less.
Note: Refer to page 3 where (parts index number) is shown
EasyTouch/IntelliTouch Control System Upgrade Kits Installation Guide
Advertisement
