Advertisement
10
Installing the IntelliCenter™ Control System Outdoor Control Panel
1. Install the IntelliCenter Outdoor Control Panel (1) and Bezel: Mount the Outdoor Control
Panel and bezel onto the enclosure. Install the two screws to secure the bezel to the
enclosure.
2. Connect the Transformer plug to the IntelliCenter Control System main motherboard
(See Figure 9).
3. Reconnect all of the low voltage connections on the main circuit board.
4. If necessary connect the IntelliChlor
wiring diagram.
5. Secure the control panel bezel to the enclosure with the two retaining screws. See Figure 10.
Figure 9. Wiring the System Transformer and Circuit Breakers (Load Center or Power center 2012 or later)
Retaining screw
Bezel screw
Figure 10. IntelliCenter Control System Outdoor Control Panel
Connecting and configuring pool and spa equipment
Please refer to the IntelliCenter Control System Installation Guide (P/N 522989) and the IntelliCenter
Control System User's Guide (522990) for the following information:
•
Connecting the system transformer (and SCG transformer option if installed) to the
IntelliCenter Outdoor Control Panel main circuit board
•
Connecting low voltage pool and spa equipment (pump, heater, spa side remote etc.)
to the IntelliCenter Outdoor Control Panel main circuit board
1. After all electrical connections have been completed, close the Outdoor Control Panel and tighten the
two retaining screws. Reinstall the High Voltage Panel: Insert the panel's three tabs into the lower
slots on the enclosure. Secure the panel with the two retaining screws. See Figure 2 on page 4.
Note: Refer to page 3 where (parts index number) is shown
EasyTouch/IntelliTouch Control System Upgrade Kits Installation Guide
®
SCG wires to COM Port J4. See Figure 11, page 11 for
Retaining screw
Bezel screw
(Figure 11 on next page)
Advertisement
