Chapter 2 - Hardware Installation; Board Layout; Led - DFI AL701 User Manual

Chapter 2 - Hardware Installation

X Board Layout
LPDDR4
Intel
Atom
LPDDR4
CAN MCU
CANBus Status LED
MXM Connector
1
EMMC
23
25
Intel I211AT
or I210IT
229
User's Manual | AL701
Top View
2
SPI Flash BIOS
24
26
PTN3460
iTE
IT8528VG
230
MXM Connector
LPDDR4
LPDDR4
Bottom View
Important:
Electrostatic discharge (ESD) can damage your board, processor, disk drives,
add-in boards, and other components. Perform installation procedures at an ESD
workstation only. If such a station is not available, you can provide some ESD pro-
tection by wearing an antistatic wrist strap and attaching it to a metal part of the
system chassis. If a wrist strap is unavailable, establish and maintain contact with
the system chassis throughout any procedures requiring ESD protection.
X LED
CAN Bus LED
Important:
When the Standby Power LED on the carrier board lights up, it indicates that there
is power on the system board. Power-off the PC then unplug the power cord prior
to installing any devices. Failure to do so will cause severe damage to the mother-
board and components.
Chapter 2
HARDWARE INSTALLATION
8