Table of Contents
Advertisement
Key
Key
Assembly
X
5. Place the cooler, i.e. heatsink or heat spreader, onto the module while making sure the
screw holes on the cooler align with the screw holes on the module. The thermal inter-
face metals underneath the cooler should also sit directly on top of the CPU and the
memory chipsets. Thermal paste shall be applied to the interfaces at this moment if it
is required.
6. Use a screw driver to fasten the screws into the screw holes. The mounting screws
may be attached to the heatsink with spings in the case of a standard package. In oth-
er cases, you may need to insert the screws that are packed separately from the cooler.
User's Manual | AL701
X I/O Connectors
MXM Connector
The 230-pin MXM connector (golden fingers) is used to interface with the carrier board. The pin
assignements are listed in the table below.
Pin
Assignment
1
GND
3
GBE_MDI3-
5
GBE_MDI3+
7
GBE_LED_100-
9
GBE_MDI1-
11
GBE_MDI1+
13
GBE_LED_LINK-
15
NC
17
WAKE-
19
GPIO0_C
21
SLP_BTN-
23
GND
25
GND
Chapter 2
HARDWARE INSTALLATION
Pin
Assignment
2
GND
4
GBE_MDI2-
6
GBE_MDI2+
8
GBE_LED_1000-
10
GBE_MDI0-
12
GBE_MDI0+
14
GBE_LED_ACT-
16
EC_PM_SLP_S4-
18
EC_PM_SLP_S3-
20
CB_PWRBTN-
22
LID_BTN-
24
GND
26
CB_PWROK_C
11
Advertisement
Table of Contents
