Preparation And Installation; Preparing The Remote Control - Canon WUX500ST Quick Start Manual

Preparation and Installation

Preparing the Remote Control

■ Installing Remote Control Batteries
1
Open the battery
compartment lid.
Slide the lid while
pressing it down.
• If buttons on the remote control are inoperative when you attempt to operate the
projector, replace the batteries with new ones.
• Do not drop the remote control or subject it to impact.
• Do not spill any liquids on the remote control. Doing so may cause a malfunction.
■ Remote Control Operating Range
The remote control is an infrared type. Point it at the infrared remote receiver on the
front or rear of the projector to operate it.
• Remote control range: up to 4 m (13.1') in front and 8 m (26.3') in back
• Use the remote control within an angle of 25° in any direction from directly in front of the
infrared remote receiver.
• The remote control may be inoperative if there is an obstacle between the remote
control and the projector or the infrared remote receiver on the projector is exposed to
direct sunlight or strong light of lighting equipment.
• When you use 2 or more projectors at the same time, you can change the channel
settings to prevent the 2 remote controls from interfering with each other.
2
Insert batteries.
Insert 2 new AAA
batteries in the
compartment with the
+ and – terminals
positioned correctly.
25°
4 m (13.1')
25°
8 m (26.3')
27
3
Close the
compartment lid.
Slide the lid until you
hear a click to
securely close it.
25°
25°