+/- 1 in.-lbs.
15) Position the calipers (D) within the caliper mounts and lightly hand tighten the mounting screws
(A). NOTE: Do not use the wrench on them until the calipers have been aligned or damage to the
brake disc could result.
16) With the caliper mounting screws (A) lightly hand tightened, engage the holding brake to correctly
position the caliper (D) orientation to the brake disc (C). Then the screws may be tightened using
the 5mm Allen wrench.
17) Bleed the brake system (see Bleeding the Brakes).
C
Figure 1
B Pair of brake pads with leaf spring
C Brake disc
D Caliper assembly
E
G
H
Quantities listed are for one side of the CooLift
1-800-MAGLINE (624-5463)
A
D
A Hex socket head cap screw - M6 x 20mm
Caliper brake line assembly (includes F, G
and H)
F
Banjo bolt
O-rings
Banjo fitting on brake line
D
Figure 2
Compressing the piston
H
Item
Page 33
Figure 3
Removing/Inserting the pads
F
G
E
E
Figure 4
Qty.
Part Number
2
80003
1
309594
1
309050
1
309595
1
309145
1
80135
2
n/a
1
n/a
www.magliner.com
CooLift
®
B