Replacing Containment Strap And Tongue - Magliner Coolift CPA Series Service Manual

1) Place the CooLift on a level flooring surface with the holding brake engaged.
2) Remove the containment strap assembly (A) by taking out the mounting screw (C) and lock nut
(D) using the two wrenches.
3) Position the new containment strap assembly (A) such that the tab sits on top of the mounting
spacer (B). Insert the previously removed screw (C) and tighten the lock nut (D) using the two
wrenches.
REPLACING CONTAINMENT STRAP TONGUE
TOOLS NEEDED: #2 PHILLIPS HEAD SCREWDRIVER AND 3/8" WRENCH
1) Place the CooLift on a level flooring surface with the holding brake engaged.
2) Remove the containment strap tongue (I) by taking out the mounting screw (J) and lock nut (H)
using the #2 Phillips head screwdriver and the 3/8" wrench.
3) Position the new containment strap tongue (J) so the tab with the rectangle-shaped hole is facing
outward from front of cart and the holes are lined up with the holes on the mounting block and
secure it with the previously removed screw (J) and lock nut (H), allowing the tongue to rotate
freely.
H
I
1-800-MAGLINE (624-5463)
REPLACING CONTAINMENT STRAP
TOOLS NEEDED: TWO 1/2" WRENCHES
Note: It is important to keep the CooLift upright at all times.
Note: It is important to keep the CooLift upright at all times.
Front
Underside
View
C
A Containment strap
A Containment strap mounting
B
spacer
B
C Screw - 3/8"-16 x 1-1/2" long
D Hex lock nut - 3/8"-16
D
Hex lock nut w/ nylon insert -
H
#10-24 UNC
I Containment strap tongue
J
J Screw - #10-24 x 2-1/2" long
Page 17
Item
Item Qty.
www.magliner.com
CooLift
®
Part
Qty. Number
1 309152
1 309150
1 79988
1 80603
Part
Number
1 80683
1 309133
1 80004