Removal And Replacement Of Components; R&R Of Voltage Supply Components - AccuTemp ACCU-STEAM G2 Series Service Manual

7. Removal and Replacement of Components.

7.1 Voltage Supply Components
Fuse .75 Amp 250V
AT0E-2731-4
1. Unplug from wall receptacle.
2. Lower front access panel by removing the
screws in the upper corners of the panel (Fig
7.1A).
3. Replace fuse.
Ensure that the fuse block holder is
secure and the fuses do not slip once in place
as this can cause ignition issues
Transformer
AT0E-2662-5
1. Unplug from wall receptacle.
2. Lower front access panel by removing the
screws in the upper corners of the panel.
3. Locate transformer and note the location
of the wires and their terminals, disconnect
wires (Fig 7.1B).
4. Removed nuts securing transformer.
5. Remove transformer.
6. Reinstall in reverse order.
Power Cord
AT0A-2911-1
1. Unplug from wall receptacle.
2. Lower front access panel by removing the
screws in the upper corners of the panel.
3. Locate transformer and note the location
of the wires and their terminals, disconnect
wires.
4. On the inside of the unit, remove the
retaining nut on the threads of the Power
Cord Cable Fitting & pullout the Power Cord
(Fig 7C).
5. Reinstall in reverse order.
SP8042-1911
Accu-Steam™ G2 Gas Service Manual
Fig 7.1A
Fig 7.1B
Fig 7.1C
19