Home Screen And Programming The System; Home Screen System Configuration - Roberts Gorden CORAYVAC Installation Manual

8.2 Home Screen and Programming the System

The following instructions provide a general overview
of programming your system. Each controller on the
network must be programmed separately. When pro-
gramming for controller is complete, select the home
icon to return to the System View screen. Select the
next controller on the network and repeat the pro-
gramming instructions. For detailed instructions,
please refer to the CORAYVAC
ulating Heating Control installation and operation
manual.
To Home Screen
To Access Individual
Zone Temperature
and Setpoint
Configuration Screens
Note: For detailed touchscreen navigation, reference
the Touchscreen Navigation Tree, located on Page
104, Section 13 .

8.3 Home Screen System Configuration

From the Home screen select <menu> to access the
list of property menus. Scroll down and select
<Configuration - Service>.
The Configurations-Service screen is used to
® /COMPLETE™ Mod-
Home Screen Map
To Alarm Manager Screen
SECTION 8: P
ROGRAMMING AND
Home Icon
Note: Prior to programming the system, ensure that
Initial Touchscreen Setup has been complete, see
Page 45, Section 5.8.
Pump On/Off
and Run % Status
adjust how many zones, vacuum pumps, and the
type of heating system that is connected to the con-
troller you are programming.
Select the box next to 'Number of Zones' and set
the number of zones connected to that controller.
Select the box next to each 'Zone "#" Selection' and
choose the type of heating system that is associated
with that zone.
Example 1: If the controller is controlling two
CORAYVAC ® systems with a combination of four
heating zones, the user must assign which vacuum
pump is associated with each zone. If zones 1 and 2
are connected to vacuum pump 1, then set 'Zone 1
Selection' and 'Zone 2 Selection' both to <Vacuum
Pump 1>. Set 'Zone 3 Selection' and 'Zone 4
Selection' to <Vacuum Pump 2>.
Example 2: If the controller is controlling unitary
heaters, select <Unitary Modulating> or <Unitary
On/Off> (depending on what type of unitary heater is
installed) to the appropriate 'Zone "#" Selection'.
T S
ROUBLESHOOTING THE YSTEM
Outside Air
Temperature
To Access
List of All Active
and Inactive Alarms
To Access List of
Property Menus
59