Commissioning; Security Check; Cutting Procedure - Pilous ARG 105 mobil Instruction Manual

5.Commissioning

5.1.Security Check

Is everything in perfect condition with regard to safety and technical condition?
Are all protective devices mounted properly?
Danger of injury!
No cover on the saw blade in the cutting area!
High risk of injury in the operating area of the blade!

5.2. Cutting Procedure

The TOTAL STOP button is unlocked. Unlock the arm swing locking lever (J), raise the saw arm (A) to approx. 20 mm above the vice
loading surface and by swinging the arm, set the required cutting angle on the angle scale and lock the arm swing locking lever (J)
again. Open the moving clamping jaw (K) to such extent that allows for unhindered insertion of the workpiece between the jaws. Push
the workpiece. You cannot align long heavy workpieces to the correct position by the moving clamping jaw. After the feed, the
workpiece must always be adjusted parallel with the fixed clamping jaw. Choose the length of the cut workpiece. Use the movable
clamping jaw (K) to clamp the workpiece. Set the correct distance of the movable guide head of the saw blade (O) to approximately
5–10 mm from the movable clamping jaw of the vice (K) and lock using the locking lever (L). Choose the cutting speed (in ARG 130
V400 only). In saws with cooling, set the required coolant volume using valves. Start the saw blade motor by pressing the switch on
the control handle (N). The rate of the feed to the cut is dependent on the pressure exerted on the arm lever. The optimum value of
descent speed can be determined very easily by ear. The saw blade movement must be noiseless, free from vibrations. Such a state
can be achieved by reducing or increasing the pressure force (by the velocity of saw arm descent). The prerequisite of setting the
optimum pressure is selecting the correct saw blade velocity and the optimum size of the saw blade teeth. After finishing the cutting,
release the handle trigger (N). The cut has been finished. Raise the arm to the default upper position.
ARG 130 Super
Pull the locking pin (Q) of the arm. After starting up the saw blade by pressing the START button, place the saw manually into the cut.
The rate of the feed to the cut is dependent on the pressure exerted by the weight of the arm. It is not necessary to push the lever,
the saw cuts automatically. The system of a pulling and pushing spring balances the descent speed. This speed can be controlled
using adjustable heads (P). If you screw the heads downwards, the machine will switch into the manual mode (then the feed is
determined by the pressure exerted on the arm lever; after finishing the cutting, the arm will automatically move to the upper
position). After you stop cutting, the saw blade will stop automatically.
A J L O K
N
Q P P