Commissioning; Security Check; Cutting Procedure - Pilous ARG 200 plus Instruction Manual

5. Commissioning

5.1. Security Check

Is everything in perfect condition with regard to safety and technical condition?
Are all protective devices mounted properly?

5.2. Cutting Procedure

Danger of injury!
No cover on the saw blade in the cutting area!
High risk of injury in the operating area of the blade!
The TOTAL STOP button is unlocked. Unlock the arm swing locking lever (M), raise the saw arm (A) to the limit upper position and by
swinging the arm, set the required cutting angle on the angle scale (S), and lock the arm swing locking lever (M) again. Open the
moving clamping jaw (N) to such extent that allows for unhindered insertion of the workpiece between the jaws. Push the workpiece.
You cannot align long heavy workpieces to the correct position by the moving clamping jaw. After the feed, the material must be
aligned. Asymmetric or thin-walled sections have to be stabilized and fixed in place using fittings made e.g. of hardwood etc. Choose
the length of the cut workpiece. Move the moving clamping jaw (N) closer to the workpiece and clamp it by the quick-clamping lever
(Z). Carefully lower the arm (saw blade)(A) to approximately 20-30 mm above the planned cross-section of the workpiece and secure
by closing the oil damper relief valve (F). Set the correct distance of the movable guide head of the saw blade (R) to approximately
5 - 10 mm from the movable clamping jaw of the vice (N) and lock using the moving bar locking lever (O). Choose the cutting speed.
Switch on the saw blade motor. Set the speed of arm descent to the cut using the relief valve. The optimum value of descent can be
determined very easily by ear. The saw blade movement must be noiseless, free from vibrations. Such a state can be achieved by
reducing or increasing the pressure force (by the velocity of saw arm descent). The prerequisite of setting the optimum pressure is
selecting the correct saw blade velocity and the optimum size of the saw blade teeth, see Section 8. Saw blades. After cutting the
workpiece, the saw blade automatically switches off.
The cut has been finished. Saw arm - the saw blade is located in the lower limit position. The saw blade stopped and the motor is
turned off. You can watch the video with instructions on www.pilous.cz.
A
O
Z
N F
R
S
M