Commissioning; Security Check; Cutting Procedure - Pilous ARG 260 S.A.F. Instruction Manual

5. Commissioning

5.1. Security Check

Is everything in perfect condition with regard to safety and technical condition?
Are all protective devices mounted properly?

5.2. Cutting Procedure

Danger of injury!
No cover on the saw blade in the cutting area!
High risk of injury in the operating area of the blade!
1) Make sure that the TOTAL STOP button is released, the blade covers are closed, and the blade is properly tensioned and adjusted.
2) Turn on the POWER SWITCH; a yellow-backlit SAFETY button will light up.
3) Turn on the hydraulic unit by pressing the button START HYDRAULIC UNIT.
4) Set the required cutting angle (see section 4.3.2).
5) Preset the required band saw arm stroke height in accordance with the material section (see section 4.9.)
6) Insert the workpiece into the vice and set the desired cut length.
7) Set the movable guide head to 30-50 mm from the cut material (see section 4.4.).
8) Shut off the CONTROL VALVE completely (see section 4.2.)
9) Select the saw blade speed (see section 6.6.)
On the control panel, select the manual or automatic mode (see section 4.1).
MANUAL MODE
10) Switch the MODE switch to the MANUAL mode
11) Use the VICE switch
12) Press the green button SAW BLADE START
the saw blade.
13) Use the green-lit START DESCENT button to activate the
descent of the arm.
14) Set the optimum arm descent to the cut speed by gradual
loosening of the CONTROL VALVE (see section 6.6.) and
carry out the cutting.
15) After the cut, the saw arm will automatically ascend to the
preset upper end position (if the arm uplift switch is in the
position 1), or the saw arm will remain in the lower position
(if the switch is in position 0).
.
to clamp the material.
to start
AUTOMATIC MODE
10) Switch the MODE switch to the AUTOMATIC mode
11) Use the green START button to activate the cutting cycle
(clamping of the material, start of saw blade drive, activation of
the arm descent).
12) Set the optimum arm descent to the cut speed by gradual
loosening of the CONTROL VALVE (see section 6.6.) and
carry out the cutting.
13) After the cut, the saw arm will automatically ascend to the
preset upper end position (if the arm uplift switch is in the
position 1), or the saw arm will remain in the lower position (if
the switch is in position 0).
.