Fault Messages At The End Of A Programme - Miele WWG 660 Operating Instructions Manual

Fault messages at the end of a programme

Problem

Check detergent

Hygiene info: Run a
programme at min.
75°C or "Clean
machine'"
programme

Align the washing
machine
The messages will appear at the end of the programme and when the washing
machine is switched on and need to be confirmed with the OK sensor.
Possible cause and remedy
Excessive foam has built up during washing.
 With TwinDos, check the dosage amount set.
 Reduce the amount set in 10% increments.
 Use less detergent next time and follow the
manufacturer's instructions on dosage given on
the packaging.
When washing, a wash programme using a
temperature above 60°C has not been run for a long
time.
 Turn the programme selector to Further
programmes/.
 Touch the  sensors until
in the display.
 Touch the OK sensor.
The following appears in the display:
 Touch the OK sensor.
 Run the
Clean machine
IntenseClean machine cleaner or a universal
powder detergent.
This will clean the washing machine and prevent a
build-up of bacteria and odours.
The Pre-ironing Extra at the end of the programme
could not be carried out properly.
 Check whether the washing machine is aligned
correctly (see "Installation – Levelling the
machine").
 Check whether the maximum drain height of 1 m
has been exceeded.
If the fault message appears again, contact Miele. The
washing machine can still be used, but without the
Pre-ironing Extra.
Problem solving guide
Maintenance
Clean machine
programme using the Miele
appears
65